The best flat roof roofing material is without a doubt an individual sheet of rubber tailor made for weather-proofing flat roofs, such as Firestone’s EPDM product.
That is laid directly onto roof boarding, itself supported by the roof rafters and nagging. Insulating material is normally laid in the space between the two, and if you are renewing your flat roof anyway you might as well take the chance of renewing that concurrently.
This will almost certainly be the recommendation you obtain from any reputable builder or roofer advising you on replacing your existing flat roof.
Until recently the most famous material for a fresh flat roof was bituminous felt laid in three layers, the first layer nailed down and top of the two bonded to the main one beneath with mastic bitumen. With respect to the material used, this may mean heating a good bitumen-based compound to make it liquid, and pouring it onto the underlying felt and spreading it evenly on the whole area of the roof.
Then Professional roofing services had to wait for the compound to cool before applying the next layer, and at the end spreading a layer of stone chippings on the roof and bonding it with a chipping compound, this being to reflect natural sunlight and prevent the felt and bitumen degrading quickly.
This was altogether a rather messy, complicated and time-consuming job best left to the professionals. In addition, there were several stages where it was very easy to fail to make the roof weather-proof, e.g. where the edge of the felt met the prevailing tile or slate roofing of the pitch roof.
On top of that, if, or rather when, there developed a leak in the flat roof, it might be very difficult and messy to find out wherever the rain was getting in. Seldom would the manifestation of the leak on the ceiling of the room below be directly below the source of it. Water could easily get by way of a weakness in the bitumen felt and travel along a rafter before descending to the ceiling board below.
The brand new generation of rubber-based flat roofing systems are far superior. When you have reasonable DIY abilities then you can probably do it yourself, with one other person to assist. You can easily look for a local supplier of rubber flat roof roofing material online, and the existing price is around �6.65 per square metre.
Most suppliers cut the material to the exact size and shape that you require so there are no unnecessary joins, meaning no weaknesses and an extremely long-lasting, leak-proof roof.
The vital section of the whole process is to ensure that there are no gaps between your rubber roof and any existing pitch roof where rain could possibly penetrate. To ensure you can find no problems it’s important to run the rubber material up and under the tiles or slates of the adjoining pitch roof so that any rain dripping from the lower-most row falls onto the rubber, without possibility of it over-lapping the edge and getting within the pitch roof.
Also, make sure that the existing slope of the flat roof towards the guttering or other means of water escape is maintained. The rubber is simply glued onto the roof boards and sealed where appropriate with metal brackets or bitumen in such a way that rain penetration is impossible. Mind that the glue covers the whole of the underneath of the rubber to be able to avoid bumps in the surface that could obstruct the drainage of the water away.
Rubber roofs have been shown to last for well over 50 years under all weathers, so it really is the only flat roof roofing material that you should consider when deciding on a new flat roof.
